|
 |
1. Unpack pieces: LitterMaid™
Litter Box, AC Adapter (in styrofoam), Disposable Waste Receptacles,
LitterMaid™ Triple-Action Tool, Use and Care Book and Cleaning
Brush (packed with Disposable Waste Receptacles), plus any optional
items including the Carbon Filters, Paw-Cleaning Ramp, Cat-Privacy
Tent, and Litter Box Carpet.
2a. Cut and remove the restraints on each end of the Rake. |
 |
2b. Peel off protective tape on the Waste Receptacle Compartment Cover and
the Battery Compartment.
Remove styrofoam on top of the Rake.
|
 |
Unit comes with initial Waste
Receptacle installed.
3a. Place a Disposable Waste Receptacle under the Waste Receptacle
Compartment Cover. Make sure that the front of the Waste Receptacle
is under the five tabs. There should be no gap between the unit
and the Waste Receptacle. |
 |
3b. Attach the Waste Receptacle Lid by inserting the
push tabs into the round holes. |
 |
Carbon Filters not included with all models.
3c. Peel off the paper strip on the Carbon Filter to expose the
adhesive. Place filter adhesive-side down in the diamond-shaped
insert in the center of the Waste Receptacle Lid; close Waste Receptacle
Compartment Cover. |
 |
4. To fill the unit, use only a premium clumping litter.
Do not use non-clumping litter, crystal or pearl-like litters. Fill
the LitterMaid™ Litter Box to just below the
“Full Line.”
5. Use the LitterMaid™ Triple-Action Tool to check that the
litter is at the correct level in the center of the unit. Do not
overfill the unit or it will not operate properly. |
 |
6a. Remove the AC Adapter from the styrofoam and
plug it into the unit.
6b. Plug the cord into a standard electrical wall outlet.
6c. Turn the On/Off Switch to "on" and a red light will
appear. |
 |
6d. The Rake will automatically run through its first cleaning
cycle and smooth out litter.
Your LitterMaid™ is now ready to use!
|
If your unit is not working properly, refer to "Troubleshooting"
in the Use and Care
Book (pg. 6).
If you need to acclimate your cat to the LitterMaid™ Litter
Box, refer to "Acclimating Your Cat" in the Use and Care
Book (pg. 5).
Optional Items
For more information, call: Toll-Free 1-800-LITMAID (548-6243) Or
visit our web site: www.littermaid.com
|
 |
Paw-Cleaning Ramp: 7a. The Paw-Cleaning Ramp has two pivot pins that
snap into holes on the side of the Waste Receptacle Compartment
Cover. Position the Paw-Cleaning Ramp with carpet-side facing up.
7b. Point the pivot pins toward the Disposable Waste Receptacle
end of the unit. Lift the Paw-Cleaning Ramp and insert one of the
pivot pins into one of the holes.
7c. Slightly stretch the other pivot pin to reach the other hole,
then insert. Tug slightly on the Paw-Cleaning Ramp to ensure it
is firmly in place.
Tent: Assemble tent to cover unit. (See instruction sheet).
|
 |
Removing Disposable Waste Receptacle:
We recommend avoiding contact with waste material. Wear rubber or
latex gloves when handling used Disposable Waste Receptacle.
8a. Depress the two push tabs in the Waste Receptacle
Compartment Cover. Detach the Disposable Waste Receptacle Lid from
the Waste Receptacle
Compartment Cover. |
 |
8b. Lift the Compartment Cover, exposing the closed
Disposable Waste Receptacle assembly.
8c. Pull the Disposable Waste Receptacle edge free from the tabs holding
it in place.
8d. To dispose of the Waste Receptacle, press in on four corners of
lid to secure lid to the Waste
Receptacle, and dispose. |
|
